![]() ![]() Slide open the remote's battery compartment.Replacement Propellors REMOTE BATTERY INFORMATION Note: If there are 2 sets of Drones within 4 meters for Pairing, you must pair one successfully before pairing the second set. Check Point: Remote Controller must be closed to Drone, not exceed 4 meters.Remote Controller and Drone can not be paired: If the above does not resolve the issue, reboot the drone and controller and pair again.Put the left remote control lever to the left bottom and put the right remote control lever to the right bottom at the same time which connected to the drone (diagram to right).Replace with the proper number replacement blade and try flying again.One or more blades are most likely damaged.Use charging cable to connect the drone to power source.Īfter trimming the drone, the drone flight is very unstable and cannot fly properly: Remote batteries are low replace them with new batteriesĭrone and remote properly pair, but the drone will not lift-off:.When the remote is switched on, the remote LED is flashing and remote is beeping: Check that batteries in the remote are installed correctly OR.When remote switch is turned on, the remote light does not illuminate: Consult the dealer or an experienced radio/TV technician for help. ![]() Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ![]() This device complies with Part 15 of the FCC Rules. Always fly safely and respect the privacy of others. Although the FAA does not require this drone to be registered, ongoing compliance with federal, state, and local laws is an owner's sole responsibility. As of December 21, 2015, the Federal Aviation Administration (FAA) only requires registration on unmanned aircrafts weighing more than.55 lbs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |